93 ford aerostar

by joshua lee
(mpls, mn, usa)

ive got a 93 ford aerostar 2wd v6 3.0 and i made a hho kit that i want to try out, and then i did more reading and apparently i should check into this efie or hho chip whatnot. I am wondering what would be the best thing for me to do, i know where the computer is located, and im looking for the cheapest, and easiest, solution possible.

Comments for 93 ford aerostar

Click here to add your own comments

93 Aerostar
by: granmar

ive got a 93 ford aerostar 2wd v6 3.0 and i made a hho kit that i want to try out, and then i did more reading and apparently i should check into this efie or hho chip whatnot. I am wondering what would be the best thing for me to do, i know where the computer is located, and im looking for the cheapest, and easiest, solution possible.

Joshua, though "cheap" and "easy" are great sounding words, "cost-effective" and "safe" are far less expensive!

If your HHO system is properly set up and you are producing the right amount of HHO (in your case, about 1.5-1.8 LPM [liters per minute] for a 3-liter engine, then IF you have an oxygen sensor (and I do not think you have) you could use an EFIE.

You should be seeing about 20-25% savings. Of course, you might have more, but that depends on the quality of Browns Gas you are creating. Remember, it is only to act as a catalyst!

An FS2 HHO chip will not work with your model of vehicle, I am afraid.

Good Luck.

Click here to add your own comments

Join in and write your own page! It's easy to do. How? Simply click here to return to HHO Gas FAQ.










| Return To Top | Home | About Us | Contact Us | Sitemap | Privacy Policy | Site Search |


541-846-8007
Hydrogen-Generators-USA.com


Copyright© 2008-2023 Hydrogen-Generators-USA.com - All Rights Reserved